Yes, you can technically shower with socks on, but it is not recommended. The socks will get wet and may become uncomfortable to wear. Additionally, wearing wet socks for an extended period of time can increase the risk of developing skin irritation or fungal infections. It is best to remove your socks before showering and put on a fresh pair afterwards. **

To install a concealed shower mixer, you will first need to locate the wall studs and mark the desired placement for the mixer. Next, cut an opening in the wall to accommodate the mixer valve. Connect the hot and cold water supply lines to the mixer valve, ensuring they are properly sealed with plumber's tape. Finally, attach the trim plate and handle to the mixer valve and test the water flow to ensure everything is working correctly. It is recommended to consult a professional plumber if you are unsure about any step in the installation process. **

The two taps of the shower mixer are likely dripping because the washers inside the taps have worn out over time. When the washers wear out, they are no longer able to create a watertight seal, causing water to leak out. This is a common issue in older faucets and can usually be fixed by replacing the worn-out washers. If the problem persists after replacing the washers, it may be a sign of a more serious issue with the internal components of the mixer that may require professional repair or replacement. **

To adjust the mixer tap in the shower, first, turn on the water to the desired temperature. Then, locate the handle or knob on the mixer tap that controls the temperature. Turn the handle or knob to the left for hotter water and to the right for colder water. Adjust the handle or knob until you reach the desired temperature. If the water pressure needs to be adjusted, there may be a separate handle or knob for that purpose. **

To replace the shower faucet, mixer tap, and thermostat in the shower, you will first need to turn off the water supply to the shower. Next, remove the handle and trim plate of the faucet to access the cartridge or valve. Unscrew and remove the old faucet, mixer tap, and thermostat, then install the new ones following the manufacturer's instructions. Finally, reassemble the handle and trim plate, turn the water supply back on, and test the new fixtures for proper functioning. **

It ultimately depends on personal preference and the specific situation. Some people may prefer the comfort and warmth of wearing socks with sandals, while others may find it more stylish to wear sandals without socks. In more casual or relaxed settings, wearing sandals with socks may be acceptable, but in more formal or professional settings, it may be more appropriate to wear sandals without socks. Ultimately, it's important to consider the overall look and comfort when deciding whether to wear sandals with socks or just socks. **

The darned socks likely end up in the shower due to being placed there accidentally or absentmindedly. It is possible that someone may have taken them off while in the bathroom and left them there, or they could have fallen out of a laundry basket or hamper onto the bathroom floor. Alternatively, they may have been used to clean up a spill or mess in the bathroom and then forgotten there. **

To remove the handle of a single lever shower mixer, you will first need to locate the set screw that holds the handle in place. This is usually located on the underside of the handle or behind a decorative cap. Use an Allen wrench or screwdriver to loosen and remove the set screw. Once the set screw is removed, you can then pull the handle off the mixer valve. Be sure to turn off the water supply to the shower before attempting to remove the handle to avoid any water leakage. **