To create a firewall rule on a MikroTik router, you can use the Winbox graphical interface or the command-line interface. In Winbox, navigate to IP > Firewall and click on the "Filter Rules" tab. Click on the "+" button to add a new rule, then configure the rule by specifying the source/destination address, port, protocol, and action (allow/deny). In the command-line interface, use the "/ip firewall filter add" command followed by the necessary parameters to create a new firewall rule. Make sure to review and test the rule to ensure it is working as intended. **

The internet speed required for cloud gaming on the Nintendo Switch varies depending on the specific game and the quality of the streaming service. However, as a general guideline, a stable internet connection with a minimum download speed of 10 Mbps is recommended for a smooth cloud gaming experience. It's also important to consider factors such as network stability, latency, and data usage when evaluating the suitability of your internet for cloud gaming on the Nintendo Switch. It's always a good idea to check the specific requirements of the cloud gaming service and games you plan to use to ensure your internet is sufficient. **

To use your D-Link router as a switch, you can disable the DHCP server function in the router's settings and connect the router to the main network using one of its LAN ports instead of the WAN port. This will essentially turn off the routing function of the router and allow it to act as a switch, extending the number of available Ethernet ports for your network. Additionally, you can also disable the wireless function if you only want to use the router as a switch. **

In case of a switch router failure, the network connectivity provided by that particular switch router will be disrupted. This means that devices connected to that switch router will lose network access. To restore connectivity, the failed switch router will need to be repaired or replaced. In the meantime, network traffic may need to be rerouted through alternative paths to maintain connectivity for the affected devices. **

To connect a router to a switch, you will need an Ethernet cable. First, locate the Ethernet port on both the router and the switch. Then, connect one end of the Ethernet cable to the router's Ethernet port and the other end to one of the switch's Ethernet ports. Make sure the devices are powered on and allow a few moments for them to establish a connection. Once connected, the router will provide internet access to devices connected to the switch. **

No, the router interface is not directly accessible through the switch. The switch operates at layer 2 of the OSI model, handling traffic based on MAC addresses, while the router operates at layer 3, handling traffic based on IP addresses. To access the router interface from a device connected to the switch, you would need to configure the switch to route traffic to the router's IP address. **

To switch from the MNet router to your own router, you will need to first disconnect the MNet router from your network. Then, you can connect your own router to the modem or network outlet using an Ethernet cable. Once connected, you may need to configure your router's settings to work with your specific internet service provider. This may involve entering your ISP's username and password, as well as any other necessary network settings. Finally, you can test the connection to ensure that your own router is now providing internet access to your devices. **

You can repurpose your old router as a Wi-Fi extender or access point to improve the coverage of your network. When the new router arrives, you can simply disconnect the old router and connect the new one in its place. Make sure to update the network settings and Wi-Fi name/password on the new router to ensure a seamless transition. **